Volume 4, Issue 2, December 2020, Page: 61-76
Strengthening of Corroded RC Bridge Piers Subjected to Seismic Loads Using UHPFRC Jacketing
Heba A. Mohamed, Department of Structural Engineering, Faculty of Engineering, Zagazig University, Zagazig, Egypt
Mohamed Husain, Department of Structural Engineering, Faculty of Engineering, Zagazig University, Zagazig, Egypt
Sayed Ahmed, Department of Structural Engineering, Faculty of Engineering, Zagazig University, Zagazig, Egypt
Received: Nov. 5, 2020;       Accepted: Nov. 16, 2020;       Published: Nov. 24, 2020
DOI: 10.11648/j.ajcbm.20200402.14      View  84      Downloads  29
Corrosion of steel reinforcement is the main damage issue for the efficiency and performance of reinforced concrete (RC) bridge piers located in aggressive environments. In this study, the possibility of strengthening corroded RC bridge piers with high corrosion leveled by ultra-high performance fiber RC (UHPFRC) jacketing was investigated numerically. The model of nonlinear 3-D finite-element (FE) was constructed by using ANSYS software. The parameters of axial force ratio, longitudinal reinforcement ratio, aspect ratio, and transverse reinforcement ratio were studied to determine their effect on the lateral load resistance of strengthening corroded RC bridge piers. The verification carried out between the constructed FE and the experimental results of ten RC bridge piers in four experimental studies. The performance of RC bridge piers under cyclic lateral displacement and axial force was studied with different ratios. Finally, a practical model to calculate the lateral load resistance of corroded RC bridge piers was proposed. The results of this research suggest that this technique could be applied for existing concrete bridge exposed in the marine environment whereas, the concentration of corrosive chlorides are high and can also use for any shape of a column and this technique allows keeping the initial dimension of the column.
Corrosion, Strengthening, Deterioration, Aspect Ratio, Lateral Displacement
To cite this article
Heba A. Mohamed, Mohamed Husain, Sayed Ahmed, Strengthening of Corroded RC Bridge Piers Subjected to Seismic Loads Using UHPFRC Jacketing, American Journal of Construction and Building Materials. Vol. 4, No. 2, 2020, pp. 61-76. doi: 10.11648/j.ajcbm.20200402.14
Copyright © 2020 Authors retain the copyright of this article.
This article is an open access article distributed under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/) which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Tapan & Aboutaha, (2008). Strength evaluation of deteriorated reinforced concrete bridge columns. Syracuse University, Syracuse, Ny.
Akkaya C. G., (2012). Seismic behavior of RC columns with corroded plain and deformed reinforcing bars. Doctor of Philosophy Thesis, Istanbul Technical University, Istanbul, Turkey.
Ma Y, Che Y, Gong J., 2012. Behaviour of corrosion damaged circular reinforced concrete columns under cyclic loading. Construction and Building Materials, No. 29, 548-556.
Shihata A., 2011. CFRP strengthening of RC beams with corroded lap splice steel bars. Master of Applied Science Thesis. University of Waterloo, Waterloo, Canada.
Ou Y. C, Tsai L. L, Chen H. H., 2012. Cyclic performance of large-scale corroded reinforced concrete beams. Earthquake Engineering and Structural Dynamics, No. 41, 593-604.
Ran Feng, Yanwen Li, Ji-Hua Zhu, & Feng Xing, (2021). Behavior of corroded circular RC columns strengthened by C-FRCM under cyclic loading. Engineering Structures, 226.
Haijun Zhoua, Yanan Xu, Yanrong Peng, Xuebing Liang, Dawang Li, & Feng Xing, (2020). Partially corroded reinforced concrete piers under axial compression and cyclic loading: An experimental study. Engineering Structures, 203.
Fib Bulletin No. 24, (2003). Seismic Assessment and Retrofit of Reinforced Concrete Buildings. State-of-Art Report, Lausanne.
Martinola, G., Meda, A., Plizzari, G. A., & Rinaldi, Z., (2010). Strengthening and repair of R/C beams with fiber-reinforced concrete. Cement and Concrete Composites, 32 (9), 731–739.
Beschi, C., Meda, A., & Riva, P., (2009). High performance fiber reinforced concrete jacketing in a seismic retrofitting application. Paper presented at the ATC & SEI conference on Improving the Seismic Performance of Existing Buildings and other Structures.
Wanga, W., Liub, J., Agostini, F., Davy, CA, Skoczylas, F., & Corvez, D., (2014). Durability of an ultra-high performance fiber reinforced concrete (UHPFRC) under progressive aging. Cem Concr Res 55, 1–13.
Meda, A., & Mostosi, S., (2016). Corroded RC columns repair and strengthening with high performance fiber reinforced concrete jacket. Materials and Structures, 49, 1967–1978.
Tastani, S., & Pantazopoulou, S. J., (2005). Recovery of seismic resistance in corrosion-damaged reinforced concrete through FRP jacketing. International Journal of Materials and Product Technology, 23 (3/4), 389–415.
Lee, C., Bonacci, J., Thomas, M., Maalej, M., Khajenpour, S., Hearn, N., Pantazopoulou, S., & Sheikh, S., (2000). Accelerated corrosion and repair of r. c. columns using CFRP sheets. Canadian J. of Civil Engineering, NRC, Special Issue on ISIS-Canada, 27 (5), 949–959.
Pantazopoulou, S. J., Bonacci, J. F., Sheikh, S., Thomas, M. D. A., & Hearn, N., (2001). Repair of corrosion-damaged columns with FRP wraps. ASCE J. of Composites for Construction, 5 (1), 3–11.
Bonacci, J., & Maalej, M., (2000). Externally bonded fiber – reinforced polymer for rehabilitation of corrosion damaged concrete beams. ACI Structural J., 97 (5), 703–711.
Debaiky, A., Green, M., & Hope, B., (2002). Carbon fiber-reinforced polymer wraps for corrosion control and rehabilitation or r. c. columns. ACI Material J., 99 (2), 129–137.
Tastani, S., & Pantazopoulou, S., (2004). Experimental evaluation of FRP jackets in upgrading RC corroded columns with substandard detailing. Elsevier Engineering Structures, 26 (6), 817–829.
ANSYS Users' Manual, Release 17.0. ANSYS, INC., Canonsburg, Pennsylvania; (2017).
ACI 374.2R-13, (2013). Guide for testing reinforced concrete structural elements under slowly applied simulated seismic loads. ACI Committee 374.
Coronelli, D., & Gambarova P., (2004). Structural assessment of corroded reinforced concrete beams: modeling guidelines. J. Struct. Eng., 130, 1214–1224.
Cape, M., (1999). Residual service-life assessment of existing R/C structures (MS thesis). Chalmers Univ. of Technology, Goteborg (Sweden) and Milan Univ. of Technology (Italy), Erasmus Program.
Molina, F. J., Alonso, C., & Andrade C., (1993). Cover cracking as a function of rebar corrosion: part 2-numerical model. Mater. Constr., 26, 532–548.
Hanjari, K. Z., Kettil, P., & Lundgren, K., (2011). Analysis of mechanical behavior of corroded reinforced concrete structures. ACI Struct. J. 108, 532–541.
ACI 318-14 A, (2014). Building code requirements for structural concrete (ACI 318-14) and commentary. American Concrete Institute, Farmington Hills, Mich.
Du, Y. G., Clark L. A., & Chan A. H. C., (2005). Effect of corrosion on ductility of reinforcing bars. Magazine of Concrete Research, 57 (7), 407–419.
Salim, R., & Murat, S., (1992). Strength and ductility of confined concrete. Journal of Structural Engineering, 118 (6).
Maaddawy, T. E., Soudki, K., & Topper, T., (2005). Analytical model to predict nonlinear flexural behavior of corroded reinforced concrete beams. ACI Struct. J., 102, 550–559.
Design of concrete structures: CEB-FIP Model-Code 1990, London, UK (1990).
Park, R, (1995). Simulated seismic load tests on reinforced concrete elements and structures. In: 10th World Conference on Earthquake Engineering, Balkema, Rotterdam, Netherlands.
Meda, A., Mostosi, S., Rinaldi, Z., & Riva P., (2014). Experimental Evaluation of The Corrosion Influence on The Cyclic Behavior of RC Columns. Eng. Struct., 76, 112–123.
Li, J., Gong, J., & Wang, L., (2009). Seismic behavior of corrosion - damaged reinforced concrete columns strengthened using combined carbon fiber-reinforced polymer and steel jacket. Journal of Construction and Building Materials, 23, 2653–2663.
Wang, X., (2003). Research of seismic performance and hysteretic mode of corroded reinforced concrete members. Master, Xi? an University of Architecture and Technology.
Goksu, C., (2012). Seismic behavior of RC columns with corroded plain and deformed reinforcing bars. PhD, Istanbul Technical University, Turkey.
Mohamed Husain, Heba A. Mohamed & Sayed Ahmed, (2017). Evaluation of non-conforming corroded bridge piers exposed to seismic loads. International Journal of Engineering and Innovative Technology, Vol. 7, 14–24.
Browse journals by subject